SUNLU FilaDryer S2

SUNLU

SUNLU FilaDryer S2

1 spool · up to 70°C · humidity sensor · prints while drying

Not tested by Nick

Specs

Spools at once1
Max heat70°C
Prints while dryingYes
Spool turns freelyYes
Humidity displayYes
Power48 W

From SUNLU's own pages. A spec SUNLU does not confirm is left out.

What it can dry

The FilaDryer S2 heats up to 70°C. Here is how that meets Bambu Lab's fan oven chart.

Reaches

  • PLA50°C
  • PETG65°C
  • TPU70°C

Does not reach

  • ABS and ASA85°C
  • PC85°C
  • Nylon and carbon blends85°C

Source: Bambu Lab Wiki: Drying filament, the fan oven column.

About the FilaDryer S2

The SUNLU FilaDryer S2 is a single spool dryer that keeps drying filament while it feeds the print. SUNLU's case for it is simple: take the moisture out of filament before it reaches the printer and you get better print quality and fewer failed prints. It suits a one printer setup where drying one spool at a time is enough.

How it feeds your printer

SUNLU says the S2 lets you print while drying. The filament keeps drying inside the box as it's fed out to the printer, so SUNLU says it's dry and ready to use when it gets there. SUNLU describes the heating as 360° surround heating. It takes the standard 1.75 mm, 2.85 mm and 3.00 mm diameters and, by SUNLU's account, all mainstream filament brands.

What to know before buying

The S2 heats to 70°C. SUNLU lists PLA, PLA+, PETG, TPU and ABS as compatible, and names PA and PC too, but those are the filaments SUNLU builds its hotter dryers for. If nylon or PC is a regular part of your printing, the S4 Pro at 85°C and the E2 at 110°C are worth a look first.

The controls are on a touch screen that SUNLU compares to using a tablet. It switches between °C and °F and has one key recommended temperature settings for different filament types, so you don't have to look up a drying temperature for each spool. SUNLU quotes two different screen sizes on the same page, so this page leaves the size out. The S2 comes in black or white, and SUNLU also sells it as a two unit set.

Compared with the rest of SUNLU's range

The S2 is the only single spool model among SUNLU's dryers here. The SP2 holds two spools at the same 70°C, and the S4 takes four 1 kg spools in one chamber, again at 70°C. The S4 Pro and the E2 are the ones to step up to when you need more heat.

Compare with similar dryers

The dryers nearest the FilaDryer S2 on spools and max heat.

DryerSpoolsMax heatPrints while dryingPriceNick
SUNLUFilaDryer S2 This dryer170°CYes$44.99Not tested
PolymakerPolyDryer173°CYes$79.99Not tested
CrealitySpace Pi V2 Filament Dryer175°CUnconfirmed$66Not tested
EryoneSnail Dryer Box M2155°CYes$69.99Not tested
ElegooH1 HT Dryer Box185°CYes$80Not tested

Store prices as of Nov 17.

Compare every dryer

More reading