SUNLU FilaDryer SP2

SUNLU

SUNLU FilaDryer SP2

2 spools · up to 70°C · humidity sensor · prints while drying · 99 h timer

Not tested by Nick

Specs

Spools at once2
Max heat70°C
Prints while dryingYes
Humidity displayYes
Timer up to99 hours

From SUNLU's own pages. A spec SUNLU does not confirm is left out.

What it can dry

The FilaDryer SP2 heats up to 70°C. Here is how that meets Bambu Lab's fan oven chart.

Reaches

  • PLA50°C
  • PETG65°C
  • TPU70°C

Does not reach

  • ABS and ASA85°C
  • PC85°C
  • Nylon and carbon blends85°C

Source: Bambu Lab Wiki: Drying filament, the fan oven column.

About the FilaDryer SP2

The SUNLU FilaDryer SP2 is a filament dryer in two parts: a heating base and a storage box, built as separate pieces. SUNLU's idea is that one product handles both drying and storing filament, and extra storage boxes can be stacked, with three as the recommended maximum. It suits someone who wants the box that dries a spool to be the same box that keeps it dry afterwards.

How it feeds your printer

Filament can run from the box to the printer while it dries. The storage box has three cable outlet holes on each side, which SUNLU says are there for printing with different sizes of filament, and it takes 1.75 mm and 2.85 mm filament. For humidity, the storage box carries its own hygrometer, so you can watch the humidity inside change in real time.

What to know before buying

The SP2 heats to 70°C, using a PTC heater with a fan. SUNLU lists three safety layers: that heater design, a secondary temperature protection switch and software temperature control. The top cover and the sealing bottom cover use silicone, and SUNLU says the box insulates well whether it's drying or storing. In storage, SUNLU measured about 25% humidity inside with the room at an average of about 50%.

The box holds two 1 kg spools, one 2 kg spool or one 3 kg spool, and SUNLU says two 2 kg rolls fit if they're its own spools. The largest spool it takes is 250 mm across and 153 mm wide, and the range runs from 0.25 kg to 3 kg. A spool roller lets you mount paper spools and even damaged spools. The storage box has a carrying handle and a recess underneath to make it easier to move.

Compared with the rest of SUNLU's range

The SP2 sits between the single spool S2 and the four spool S4, and all three stop at 70°C. The E2 takes the same largest spool as the SP2, 250 mm across and 153 mm wide, but heats to 110°C and anneals, and SUNLU builds it for engineering filaments. The S4 Pro, at 85°C with two independent zones, is the other step up in heat.

Compare with similar dryers

The dryers nearest the FilaDryer SP2 on spools and max heat.

DryerSpoolsMax heatPrints while dryingPriceNick
SUNLUFilaDryer SP2 This dryer270°CYes$69.99Not tested
CrealitySpace Pi V2 Plus Filament Dryer275°CYes$89Not tested
EIBOSPolyphemus filament dryer280°CYesAmazon onlyUses it
SUNLUFilaDryer E22110°CYes$249.99Not tested
SUNLUFilaDryer S2170°CYes$44.99Not tested

Store prices as of Nov 17.

Compare every dryer

More reading