What the CreatBot D1000 Pro HS is
The D1000 Pro HS is CreatBot’s one cubic metre industrial FDM printer and the largest machine in its Large Format Series. CreatBot says it’s upgraded from the D1000, as a high speed version built on Klipper firmware, and Planet 3DP lists it as the newer model for the D1000 HS. The build volume is 1050 x 1050 x 1050 mm with one nozzle, or 995 x 1050 x 1050 mm when both nozzles print. CreatBot doesn’t publish a price. Its page offers a quote instead, so this listing shows the machine as sold by quote.
Speed and flow
CreatBot gives a maximum print speed of 600 mm/s and calls that five times the speed of the D1000. The hot end is rated at a flow of 90 cubic mm per second and heats to 400°C in about two minutes, with a top nozzle temperature of 420°C. Nozzles come in 0.3, 0.4, 0.6, 0.8 and 1.0 mm, with 0.6 mm fitted. Filament is 1.75 mm, and the machine takes large 2 x 5 kg spools for long jobs.
Two nozzles that stay out of the way
Both extruders lift automatically, and a mechanical shutter closes over the idle nozzle so it can’t ooze onto the part. An HD camera works out the XY offset between the two nozzles, and two photoelectric sensors handle Z. If the main nozzle runs out of filament, a backup mode carries on with the second one. CreatBot pitches the pair at soluble supports, multi material parts and two colour marking.
Built for engineering materials
The chamber is actively heated to 80°C behind insulation, the bed reaches 120°C, and a built in dry room holds filament at up to 70°C. CreatBot lists materials from PLA and PETG through ABS, ASA, PC and nylon to carbon fibre grades such as PA-CF, PET-CF and PPS-CF. Bed levelling uses an eddy current sensor, and four independent Z motors keep the plate parallel to the gantry. Motion runs on heavy duty linear rails and servo motors. There’s also a HEPA and carbon air filter, a safety door lock, power loss recovery and a 10 inch touch screen.
Size, power and what we don’t know
The machine measures 1870 x 1430 x 1940 mm and weighs 675 kg. The printer and the chamber are each rated at 6000W, on 220 to 240 V. Every figure here is CreatBot’s own, from its D1000 Pro HS page, read on 27 October 2026. Planet 3DP hasn’t tested this machine. CreatBot doesn’t give a launch date or a price, so neither is listed.