What the LulzBot TAZ 8 XT is
The TAZ 8 XT is the tall version of LulzBot’s TAZ 8. It keeps the TAZ 8’s 295 by 295 mm bed and roughly doubles the height, to a maximum print volume of 295 x 295 x 582 mm, or 11.5 x 11.5 x 22.9 inches. LulzBot designs and builds it in Fargo, North Dakota, and pitches it at professionals who need tall parts in one piece. On 27 October 2026 LulzBot’s own US store sold it in one configuration at 7,495 dollars.
Built around one big tool head
Where the TAZ 8 lets you choose a tool head at checkout, the XT ships with the Asteroid 285. It’s LulzBot’s large layer head with a 1.2 mm GammaMaster steel nozzle, and the equipped layer height runs from 0.3 to 0.9 mm. That suits tall, chunky prints more than fine detail. Across the platform’s other tool heads LulzBot quotes 0.05 to 1.8 mm. It takes 2.85 mm filament as standard, with 1.75 mm optional depending on the head. Tool heads swap without tools, using a magnetic cap and thumbscrews.
Heat, motion and speed
The hot end reaches 290°C. The magnetic flex bed is rated to 80°C, lower than the standard TAZ 8’s 110°C. X and Y run on linear rails, and Z on 12 mm rods with polymer bushings. LulzBot gives a maximum travel speed of 150 mm/s, firmware limited, against 500 mm/s on the TAZ 8. That’s a travel figure rather than a print speed, so the spec table leaves print speed blank.
What it shares with the TAZ 8
The XT has the same active bed cooling, which LulzBot says cuts cool down times by more than half, plus runout and jam detection and a glove friendly resistive touch screen. Bed levelling uses a BLTouch probe with a 32 point mesh, and the printer calibrates X axis tramming, Z offset and backlash by itself. It runs Marlin, slices with Cura LulzBot Edition, and prints from an 8 GB SD card or over USB. An enclosure is an optional accessory.
What we don’t know
Every figure here is LulzBot’s own, from its TAZ 8 XT store page, read on 27 October 2026. Planet 3DP hasn’t tested one. LulzBot hasn’t published a launch date for the XT, so no release date is listed, and it doesn’t give a print speed or a weight.