What the LulzBot TAZ 8 is
The TAZ 8 is LulzBot’s open frame professional FFF printer, designed and built in Fargo, North Dakota. LulzBot unveiled it on 25 March 2025, and its store page was taking orders that same day. LulzBot pitches it at manufacturers, research labs and production teams that run printers around the clock, and calls it print farm ready. Planet 3DP lists it as the newer model for the TAZ Pro, LulzBot’s earlier dual extruder machine, which LulzBot’s own store no longer has available to buy.
Price and tool heads
LulzBot sells the TAZ 8 on its own US store, and the price depends on the tool head you pick. We read the prices on 27 October 2026. With the Meteor 175 or Meteor 285 single tool head it costs 5,395 dollars. The Asteroid 285, a large layer head with a 100W heater and a 1.2 mm nozzle, is 5,795. The Twin Nebula 175 and Twin Nebula 285 dual extrusion heads are 5,995. LulzBot’s launch post says the factory options focus on the Twin Nebula heads, which print two materials or two colours in one part. Tool heads swap without tools, using a magnetic cap and three thumbscrews.
Size, heat and motion
LulzBot gives the maximum print volume as 295 x 295 x 285 mm. The hot end reaches 290°C and the magnetic flex bed 110°C. Layer height runs from 0.1 to 0.4 mm with the equipped head, and from 0.05 to 1.8 mm across the platform’s tool heads. X and Y run on linear rails, and the Z axis has independent gearboxes on 12 mm rods. LulzBot quotes a maximum travel speed of 500 mm/s, firmware limited. That’s a travel figure, not a print speed, so the spec table leaves print speed blank.
Features aimed at uptime
The TAZ 8 is LulzBot’s first printer with active bed cooling, which LulzBot says cuts cool down times by more than half between jobs. A BLTouch probe builds a 16 point mesh, and the printer calibrates X axis tramming, Z offset and backlash by itself. Sensors watch for filament runout and jams. The touch screen is resistive, so it works with gloves on. It runs Marlin on a 32 bit Archim 2.2b board, slices with Cura LulzBot Edition, and prints from an 8 GB SD card or over USB. An enclosure is an optional accessory. LulzBot lists PLA, TPU, ABS, PETG, PVA, PVB, nylon and PC among the materials it prints.
What we don’t know
Every figure here is LulzBot’s own, from its TAZ 8 store page and launch post, read on 27 October 2026. Planet 3DP hasn’t tested a TAZ 8. LulzBot doesn’t publish a print speed, a weight or a footprint on the page, so none is listed.